dtt255 Posted March 19, 2013 Share Posted March 19, 2013 Ok tried a search before I posted...for the record. I was finding that I was getting a mess everywhere of gun powder AFTER I fixed the sticking shell plate issue. After a little searching i found that the brass end of the powder sensor that goes into the casing is having gun powder stick to it every time it checks a load. ummm I am at a loss as to how to fix this.... If it was literally a few grains I would not care, but this thing is making a huge mess now! Anyone? Quote Link to comment Share on other sites More sharing options...
SD1 Posted March 19, 2013 Share Posted March 19, 2013 Clean with Alcohol. Wax. Some powders like Dryer sheets and some others like Graphite Caked to tip. Quote Link to comment Share on other sites More sharing options...
dtt255 Posted March 19, 2013 Author Share Posted March 19, 2013 Clean with Alcohol. Wax. Some powders like Dryer sheets and some others like Graphite Caked to tip. Ok I'll try that. Thanks! Quote Link to comment Share on other sites More sharing options...
Powder Finger Posted March 19, 2013 Share Posted March 19, 2013 clean then static guard or sheets. you can also put it in a tube with some ball powder like hs6 (20 grains should do), seal the tube and toss it in your tumbler for a while. the coating on the powder will attach to the rod then it won't attract so much. P.S. toss the powder you used. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.