goose2125 Posted February 28, 2013 Share Posted February 28, 2013 I have a sti sm in hard chrome and have now decided i want a slide racker. I have a friend with a cnc mill but was worried that the hard chrome will chip anyone done this ? Quote Link to comment Share on other sites More sharing options...
pbairborne Posted February 28, 2013 Share Posted February 28, 2013 I had Doug Jones (Acc u Rail) mill slots and install slide rackers on 2 of my STI open guns. There was no chipping of the chrome and no need to do any refinish work. His work was beautiful. Quote Link to comment Share on other sites More sharing options...
GuildSF4 Posted February 28, 2013 Share Posted February 28, 2013 It should not chip if the chrome was applied properly. If it does then your chrome job has issues and may need to be re-done. (Make sure the end mills are sharp and clean before cutting.) Quote Link to comment Share on other sites More sharing options...
lcs Posted February 28, 2013 Share Posted February 28, 2013 If done right--no problem---except the part cut is now exposed and can rust. Quote Link to comment Share on other sites More sharing options...
sandman76 Posted February 28, 2013 Share Posted February 28, 2013 Does anybody know what degree of angle that dovetail ???? Quote Link to comment Share on other sites More sharing options...
goose2125 Posted February 28, 2013 Author Share Posted February 28, 2013 Nice now i just have to find a badass one that exits the right side u know since im LEFT HANDED ! hahaha Quote Link to comment Share on other sites More sharing options...
EkuJustice Posted February 28, 2013 Share Posted February 28, 2013 Cheely shorty works good in the right side. I run one one mine as a right handed shooter due to the setback mount and it works well Quote Link to comment Share on other sites More sharing options...
goose2125 Posted February 28, 2013 Author Share Posted February 28, 2013 Ok i will go give it a look Quote Link to comment Share on other sites More sharing options...
Paul-the new guy Posted March 2, 2013 Share Posted March 2, 2013 (edited) I cut my hard chromed slide to install a Brazos zig racker. No chips and no problems. Edited March 2, 2013 by Paul-the new guy Quote Link to comment Share on other sites More sharing options...
Shadyscott999 Posted March 3, 2013 Share Posted March 3, 2013 Nice now i just have to find a badass one that exits the right side u know since im LEFT HANDED ! hahaha Check out the SVI racker along with the Cheely. Quote Link to comment Share on other sites More sharing options...
goose2125 Posted March 3, 2013 Author Share Posted March 3, 2013 I ended up ordering a racker from cheely. Should be here in a fee days. Quote Link to comment Share on other sites More sharing options...
.jpeg.02cfa736039d7c2422a836985c273500.jpeg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.