Jackruger Posted February 27, 2013 Share Posted February 27, 2013 (edited) I am ready to order the Square Deal B press for 38 special and a 9mm caliber conversion. For the 9mm conversion, do you recommend the toolhead, or the quick-change toolhead which includes the powder measure? Also what is the best way to store the extra toolhead or the quick-change toolhead? Thanks for the advice. Edited February 27, 2013 by Jackruger Link to comment Share on other sites More sharing options...
mlmiller1 Posted February 27, 2013 Share Posted February 27, 2013 The quick change makes it very handy to change between calibers. Could save a lot of time & effort. Link to comment Share on other sites More sharing options...
Merlin Orr Posted February 27, 2013 Share Posted February 27, 2013 If you can ..... go Quickchange ... Dillon sells a stand for the head.... Link to comment Share on other sites More sharing options...
Jackruger Posted February 27, 2013 Author Share Posted February 27, 2013 Thanks for the information. I wasn't aware there is a stand for the SDB toolhead. The only toolhead stand I could find was for the 550/650. Could you please send me a link for the SDB toolhead stand? Thanks. Link to comment Share on other sites More sharing options...
kevin c Posted February 28, 2013 Share Posted February 28, 2013 I use one powder measure for all my SDB conversions. Twiddling the knob to get the right drop doesn't bother me, but I'll grant that I change calibers infrequently. All the toolheads (I have them in 9mm, 40 S&W/10mm, 44 mag and 45 ACP) and the dies fit into a box smaller than a shoe box that goes under the bench. The more or less permanently mounted SDB holds the measure and the current setup. Link to comment Share on other sites More sharing options...
Babaganoosh Posted February 28, 2013 Share Posted February 28, 2013 I have a complete set up for each caliber. When I first started to load I had 1 measure. Just add slowly as you go. Link to comment Share on other sites More sharing options...
dapribek Posted February 28, 2013 Share Posted February 28, 2013 I don't believe Dillon sells a tool head stand for the SDB. Link to comment Share on other sites More sharing options...
Bunsen Posted February 28, 2013 Share Posted February 28, 2013 If you can afford it go with the quick change toolhead which includes the powder measure. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now