treefarmer Posted October 21, 2012 Share Posted October 21, 2012 I am considering putting on a D. P. ice magwell on my 16-40. will they " drop " in or will some fitting be required? I have Dawson mag. extensions. Any problems with them? Thanks for the info. T. F. Link to comment Share on other sites More sharing options...
furyalecto Posted October 23, 2012 Share Posted October 23, 2012 (edited) I dropped one in without any issues. It is a little tighter to seat the mags, but not a problem. I followed the directions & tested. Edited October 23, 2012 by furyalecto Link to comment Share on other sites More sharing options...
Anopsis Posted October 24, 2012 Share Posted October 24, 2012 Using Dawson basepads, I had to use my Dremel to create little divots in the plastic insert on each side at the rear, right where the rear corners of the basepad made contact. I have switched to STI mags and the Dawson pads do not touch it. Link to comment Share on other sites More sharing options...
JGus Posted October 26, 2012 Share Posted October 26, 2012 (edited) I had a Para P16-40 Limited (just sold it very recently, fantastic gun, I just had enough guns for Limited and wasn't going to use it) and I added a Dawson NON Ice magwell. Fit perfectly with no fitting required. Thanks to Furyalecto's advice I found out I could run my STI mags in it just fine. Edited October 26, 2012 by JGus Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now