quedude Posted September 2, 2012 Share Posted September 2, 2012 (edited) Does anyone here know if a STI 2011 and a Para 16-40 will fit in the same holister block for the DAA Racemaster? Thanks Edited September 2, 2012 by quedude Link to comment Share on other sites More sharing options...
SNSCaster2 Posted September 2, 2012 Share Posted September 2, 2012 You'll have to get another block, for a 1911/Para. Link to comment Share on other sites More sharing options...
quedude Posted September 2, 2012 Author Share Posted September 2, 2012 Are they hard to change out and do you have to take it apart and loose the set up? Link to comment Share on other sites More sharing options...
SNSCaster2 Posted September 2, 2012 Share Posted September 2, 2012 Very easy to swap out. Link to comment Share on other sites More sharing options...
gng4life Posted September 2, 2012 Share Posted September 2, 2012 No, it's not hard...but you will be taking out the tensioning screw so you will have to set it back up once again with the right amount of tension you like. Just be sure not to flip the aluminium spacer inside when you put it back together, it will cause some weird issues... Link to comment Share on other sites More sharing options...
EkuJustice Posted September 2, 2012 Share Posted September 2, 2012 can be swapped in a couple min with no loss of holster settings From Saul himself Link to comment Share on other sites More sharing options...
quedude Posted September 2, 2012 Author Share Posted September 2, 2012 Thanks for the info going to post a add in the classifieds to see if I can find one used. Link to comment Share on other sites More sharing options...
67ls7vert Posted September 2, 2012 Share Posted September 2, 2012 Does this work for the Ghost as well? Link to comment Share on other sites More sharing options...
gng4life Posted September 2, 2012 Share Posted September 2, 2012 can be swapped in a couple min with no loss of holster settings Right, but you will need to re-adjust your tension since the tension screw has to be removed...the rest (height, angle, etc.) are untouched obviously... Link to comment Share on other sites More sharing options...
EkuJustice Posted September 2, 2012 Share Posted September 2, 2012 you adjust the tension but its stilla 2 min job. I know where I want the screw for the tension i want. Screw it in and a couple draws and its set. The Ghost dosent have insert blocks so its one holster per gun. Thats one of the reasons i went with the racemaster is I can have one holster and for 40 mbucks buy a locking block to change it over. For open, I shoot an STI but have a full glock open gun for a backup. If I have a problem, swap the insert block and I can convert my gear over in a few min. Link to comment Share on other sites More sharing options...
CocoBolo Posted September 7, 2012 Share Posted September 7, 2012 The Ghost is also a fine holster, and to switch guns you need to buy a holster assembly $70.00. I have both in fact I have 2 Ghost, but I run the DAA all the time now, just seems a bit more secure than the Ghost and easier to unlock during the draw. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now