Any hints for setting up the Super Swage 600 to work with 9mm brass

[Extractor]

Any hints for setting up the Super Swage 600 to work with 9mm brass?

Is there a special way to set it up? I will only be using it for 9mm brass (of mixed heritage) would it be worth getting the .45cal insert turned down on a lathe to accept 9mm brass as there seems to be a fair amount of slop and play on the rod that is meant to be used for 9mm.

I have a lot of Norma, S K, G F L and some PMC brass that I am having trouble putting Federal primers in using the XL650 the primer pockets are really tight compared to th WIN brass that I can feel the primers go in so much easier.

I would like to prepare all the brass so it's the same as the WIN brass in regards to easiness of seating primers.

Is it easy to enlarge/swage the pocket to far and have primers loose? The setup instructions from Dillon weren't all that instructional, so any advice would be greatly appreciated.

[Coleman]

If you have your own lathe make your own rod, or find a piece of plastic tubing that will fit over the rod, but still let the case slide off.