Sight options for the Benelli M2

[Mike in CT]

I am looking at all the options and this one was mentioned in another post. It IS a shotgun sight kit, and all it needs in one hole drilled tapped in the front sight.

http://www.midwayusa.com/product/639204/hiviz-four-in-one-sight-set-shotgun-with-313-to-375-vent-rib-and-removable-front-bead-fiber-optic-with-6-interchangeable-lite-pipes

This looks like it would allow for POA, POI adjustments for Slugs,

Anyone using this?

Mike

[spd522]

I am looking at all the options and this one was mentioned in another post. It IS a shotgun sight kit, and all it needs in one hole drilled tapped in the front sight.

http://www.midwayusa.com/product/639204/hiviz-four-in-one-sight-set-shotgun-with-313-to-375-vent-rib-and-removable-front-bead-fiber-optic-with-6-interchangeable-lite-pipes

This looks like it would allow for POA, POI adjustments for Slugs,

Anyone using this?

Mike

I had it on my 21" M2. The problem is the rear sight needs to fit a bit lower so you have to mount it way back on the rib. It's not where it naturally wants to fit because the of the support bar between the rib and barrel is right where you need to attach it. You can get it to work but I couldn't ever get the plastic to lay flat on the rib. It always wanted to twist once I put the screws in to hold it. As I said, it worked but looked crooked. I ended up taking the rear off and putting the triangle front fiber optic tube in. I just shot slugs until I figured out the hold for various distances. I think the better rear solution is the 10/22 or XS sight milled into the rear of the rib. Check with Trapr (RNT), C-Rums, or Accurate Iron.

Craig

Edited February 9, 2012 by spd522