Loki999 Posted January 12, 2012 Share Posted January 12, 2012 Hi all, I'm still very happy with my shadow, the only thing i don't like is the fixed rear sight. In ipsc production we are not allowed to change the rear sight to an LPA. The poi is to low Now i took a little off the top of the rear sight and the poi is higher. But i cannot explain why? With a normal adjustable sight when you lower the complete sight by adjusting it the poi is lower. Anyone?? Link to comment Share on other sites More sharing options...
ck1 Posted January 12, 2012 Share Posted January 12, 2012 Doesn't scan, sounds like it might be you mang. Maybe you're not aligning the front the same..? Link to comment Share on other sites More sharing options...
Torogi Posted January 12, 2012 Share Posted January 12, 2012 Maybe you took too much material off the rear? If it is too high then adjust your front sight height too. You didn't mention you shaved both front and rear. I HOPE you are doing all of this from bench and being consistent with your POA. Link to comment Share on other sites More sharing options...
Loki999 Posted January 12, 2012 Author Share Posted January 12, 2012 I only took some material from the rear, 4 tenths of à mm. My gunsmit did it for me. Maybe its because the notch is smaller now and i cant the gun more Link to comment Share on other sites More sharing options...
Philo_Beddoe Posted January 12, 2012 Share Posted January 12, 2012 In ipsc production we are not allowed to change the rear sight to an LPA. Why? 17.2 Aftermarket open sights (see Rule 5.1.3.1) are permitted, provided their installation and/or adjustment requires no alteration to the handgun Wouldnt these sights use the existing cut in the slide? LPA Link to comment Share on other sites More sharing options...
Loki999 Posted January 13, 2012 Author Share Posted January 13, 2012 Thanks for the reply, i think that rearsight is to small. There is another lpasight but then there is milling recuired. Well u guess it wil stay a mystery to me, why the gun impacts higher. Thanks for the replies Link to comment Share on other sites More sharing options...
Loki999 Posted January 19, 2012 Author Share Posted January 19, 2012 [Doesn't scan, sounds like it might be you mang. Maybe you're not aligning the front the same..? /quote]Breaking my head for a week over this issue. Its probaly the above, i see less of the slide now, because of a different angle Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now