claybreaker Posted December 28, 2011 Share Posted December 28, 2011 (edited) I'm having problems with the spring that is between the two bell cranks on the power charger. The bottom on the spring has a bend that I assume fits in the hole in the bottom bell crank. After loading a few rounds I notice the spring pops out of the hole. Does anyone else have this issue or is there a fix to keep this spring in place? I think the spring just takes up the slack and does not affect the powder drop, but I know it is not right. Thanks for any suggestions. Edited December 28, 2011 by claybreaker Quote Link to comment Share on other sites More sharing options...
Youngeyes Posted December 28, 2011 Share Posted December 28, 2011 The spring is pictured on page 4 of the dillon manual. Is it possible that you are not putting the return rod through both holes? That might catch and flip the spring. No matter what the spring should stay put. If you can't figure it out call Dillon. Quote Link to comment Share on other sites More sharing options...
dillon Posted December 28, 2011 Share Posted December 28, 2011 It sounds like the spring is defective. Contact us, either by phone or online, and we'll mail a replacement. If you email us, please include your mailing address. Quote Link to comment Share on other sites More sharing options...
.gif.53c483221c1b60d84bce93d42c5def5a.gif)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.