Comp-Tac Twin Mag Pouch

[BBBB]

I am using a Comp-Tac Twin Mag pouch for my XDM on a 1.5" Wilderness instructors belt (it is the version of the pouch designed for a 1.5" belt) for IDPA. I find the pouch tends to move more on the belt than I would like. I feel this is affecting my reloads since the magazine is not always in the same place. I am wondering if anyone else has run into this and what of anything they did to solve it.

[The_Vigilante]

Try using tape/velco to build up the inside of the holster where it meets the belt.

[Aircooled6racer]

Hello: Try a CR Speed inner belt. It is thicker and works better than the Wilderness belt. The Comp-Tac leather belt works also. I also like the 2 single Comp-tac mag holders better with either the Tek-Loc or standard belt mount. Hope this helps. Thanks, Eric

[2MoreChains]

Can you thread the mag pouch onto your belt so that one of the belt loops is trapped between the two pouches? Or position the mag pouches between two belt loops so the loops limit how much movement there is fore and aft?

[czambesi]

Can you thread the mag pouch onto your belt so that one of the belt loops is trapped between the two pouches? Or position the mag pouches between two belt loops so the loops limit how much movement there is fore and aft?

I put a loop in between and use comp tac belt

[BBBB]

Thanks for the suggestions. I'll try some of them and post back if I figure something out that improves the situation.