Jump to content
Brian Enos's Forums... Maku mozo!

base pads binding in magwell


glefos

Recommended Posts

The back of the Henning basepads are jamming against the inside of the magwell. Not happening on .40cal tubes. Only doing it on the 10mm tube.

The magwell is aligned externally. However, the inside of the magwell is not quite flush with the inside of the rear of the mag opening. The contact point of the basepad and the magwell which is causing jamming is right in the middle of the relief pocket for the basepad retention screw.

Is there an issue with the tolerances on the magwell? Has anyone else had an issue and if so what is the fix?

Link to comment
Share on other sites

Which magwell is it? I know the holes for the magwell bolt between my Limited and my Hunter were off. I had to tap the bolt on on my Hunter where my Limited pushed through buy hand.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...