SVI4ME Posted March 27, 2011 Share Posted March 27, 2011 I dont know how I did it but I started to break decapping pins. I looked at the shaft that the decapping pin screws into and it is bent. This is for a .223. Think they will replace or am I out of luck? Link to comment Share on other sites More sharing options...
GrumpyOne Posted March 27, 2011 Share Posted March 27, 2011 I would think they would replace it.... Link to comment Share on other sites More sharing options...
Sarge Posted March 28, 2011 Share Posted March 28, 2011 I concur with Grumpy. They should make it right. Link to comment Share on other sites More sharing options...
SVI4ME Posted March 29, 2011 Author Share Posted March 29, 2011 Called Dillon and they are sending out another to replace the bent part. They said they replace it for free ONCE. Why buy anything else but Dillon Link to comment Share on other sites More sharing options...
Akula Posted April 12, 2011 Share Posted April 12, 2011 They replaced my twisted shaft. I was so stupid in twisting up the shaft during a 'stuck case' situation. Kudos to Dillon CS. Link to comment Share on other sites More sharing options...
Olivers_AR Posted April 14, 2011 Share Posted April 14, 2011 (edited) Just sent my .223 decapping die in, wedged the case in too bad to get out. Hopefully I'm get it back so that I can reload .223 again. To be fair, broke 2 decapping pins on the Lee decapper as well. ETA: I did the same thing: They replaced my twisted shaft. I was so stupid in twisting up the shaft during a 'stuck case' situation. Kudos to Dillon CS. Edited April 14, 2011 by Olivers_AR Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now