lucas Posted March 29, 2004 Share Posted March 29, 2004 I tried the 7 shell with 2 pac 3 gun gear stuff,but shells kept falling out of my hard kicking benelli ,so i replaced it with a 6 shell plastic side saddle and now that is also dropping way to many rounds on the ground.for gun to work i have to use 3 3/4 dr loads.Could this be the problem?When i get my new bennelli thats being built ,it is supposed to work with 3 dr loads, i can only hope problem goes away.I knew the web stuff wore out,but not the plastic side saddles. Link to comment Share on other sites More sharing options...
Gary Stevens Posted March 29, 2004 Share Posted March 29, 2004 My Super 90 works just fine with 2 3/4 dram. Have you got one of the old M-1 Benelli's? They were set up to work with heavy loads. Link to comment Share on other sites More sharing options...
EricW Posted March 29, 2004 Share Posted March 29, 2004 Are you *sure* your Benelli won't work with less than a magnum goose load? My cousin thought his Benelli would only run heavy duty stuff, but my homebrewed clays loads (about 3 -3 1/4dram) cycled his gun fine. Link to comment Share on other sites More sharing options...
Chris Posted March 29, 2004 Share Posted March 29, 2004 I saw one side saddle shell thingy where the guy put some screws in between the "fingers" that hold the shells. The screws push against the "finger" and all ow you to adjust the tension. Link to comment Share on other sites More sharing options...
benny hill Posted March 29, 2004 Share Posted March 29, 2004 make sure the shells are comming out the top side of the saddle. If they are not pushed in far enough , they will fall out. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now