Cameron Posted March 9, 2004 Share Posted March 9, 2004 I have a pile of used brass that I am running through a case pro. I found that just sizing was pushing material to tha bottom of the case enough to not allow the case in the gage. So off to the case pro I go. The only problem is, the brass is very difficult to get started through the case pro, and is actually leaving a small dent/brass smear on and near the rim. The only thing I can figure is this brass has been loaded several times, and I know it was loaded to 180 PF. Any suggestions? Just deal with it and make this the last load on this brass? Quote Link to comment Share on other sites More sharing options...
uscbigdawg Posted March 16, 2004 Share Posted March 16, 2004 Had this problem too. It was creasing the rim and the body. Try adjusting the stop and lube the Case-Pro. Corrosion-X is great. Rich Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.