Search the Community
Showing results for tags 'unable'.
Found 1 result
I recently obtained my Shadow 2 Optic Ready. I had already purchased 2 Vortex Venom RDS months ago in anticipation for taking possession of the Shadow 2 OR as well as the P10F OR when it’s available in Canada. When I received the Shadow, I went about removing the rear sight plate, not a problem; installing the CZ Vortex Venom adapter plate to the Shadow, not a problem; installing the Vortex Venom to the adapter plate; big problem. The included hardware sunk into the foam, meant to secure the red dot to the adapter plate, did not fit the adapter plate. Try as I might, the bolts would not grab hold. Eventually I pulled out the calipers and started measuring and discovered that the bolts were about 1mm larger than the contact points of the adapter plate and in the right light, I noticed the wear on the ends of the bolts where they were wearing themselves on the surface of the adapter plate. As I had already been playing with the RDS, the box and contents it had contained were thoroughly rummaged in. I decided to open the brand new Venom box to see if the bolts included in there were a different size and that’s when I noticed the baggie labeled GLOCK MOS containing two additional bolts. These fit. So what I had done was stash that baggie under the foam in the original box because I don’t own Glock products (never will) so I figured the baggie with the bolts was of no use, glad I didn’t toss it though. Anyways, I’ve gotten a number of people watching my video on the Shadow 2 optic ready on Youtube, asking me about mounting the Vortex Venom as they are running into the same problem. Not all Vortex Venoms, be it 6MOA or 3MOA are shipping with that GLOCK MOS package of bolts, and you NEED those. I had contacted my retailer of the optic plate and they suggested the problem is with the Venom. The problem is not with the Venom. I think CZ didn’t tap the holes big enough to use the mounting hardware that Vortex provides with all their Vortex Venoms, that being the larger bolts stuck in the foam. If you’re running into problems, you may need to contact Vortex for the smaller bolts. I was at the point where I was going to either tap a larger opening into the adapter plate or reduce the size of the bolts in the foam, fortunately I didn’t have a tap/die set that would work for this and spent the time hunting for what was missing in the install. Good luck and hope this helps!