Search the Community
Showing results for tags 'production division'.
Found 4 results
Hi guys, Hoping someone can chime in and help steer me in the right direction here...Shot a little indoor match last night (4 stages) and had several light strikes/hammer falls on each stage. This is my match gun, barely has 1K rounds through it. I have never had this happen with this pistol (practice gun was a different story) so i want to get this squared away before my next match. Here is my current set up: Ammo: Blue Bullets 125g Winchester small pistol primers Vectan BA 9.5 powder OAL @ 1.125 +/- Mixed range brass Pistol: Stock barrel reamed to SAMI spec by Patriot Defense PD BOLO (fitted with the help of PD) 10lb recoil spring 15.5 PD hammer spring PD optimized trigger return spring PD optimized sear spring PD optimized firing pin spring Extreme firing pin (polished) Extreme one piece sear (polished) Extended firing pin block Stock plunger (polished) Stock plunger spring Titan hammer (base and holes polished as instructed) All applicable internals polished for smoother action/lighter trigger pulls, but nothing too crazy (I do not have trigger pull weights to disclose unfortunately) I case gauge every single round i load before matches as well as practice, and this time was no different. I'm not concerned about crazy light trigger pull weights, etc. I set this gun up with the intention of 100% reliability at matches. This is the first and only time she has behaved this way so my initial reaction was a bad/hard batch of primers but I'm not fully bought into that idea yet... I haven't changed a single thing over the past several matches where she ran 100% with this exact set up (ammo included) Thanks in advance for any help/advice you fellow shooters can offer. -Chase
Just read that content in posts are un-editedable after 2 days, so plans to update this post won't work. So I'll keep it simple. Current plans for Production Division using a CZ S2. Living in Vermont but plan to travel around and go to various matches. Have just a few match experience with G34. Looking forward to shooting this new one. Basic plans include: - reading up on rules relating to the new S2. - breaking down the S2 and learning the internal mechanics. - shooting the new S2 a lot and getting used to the DA starts. - figuring out what is needed to bring a pistol across state lines, to compete in matches during travel. - meeting other shooters and learning as much as I can from them. (includes searching for forum posts applicable to S2 used in production division) - * figuring out if the light blue aluminum grips need to be swapped for black ones...lol. Looking forward to the experience
Hello, I am new to the forum and didn't see anything about FNS 9 LS specifically under the Factory pistols "other" category for the FNS 9. I would like to know if others have found a way to make the trigger better (it's my one complaint about the firearm) Since my XDM is down for now due to worn springs, I want to use this in production, but the trigger is atrocious. Any suggestions out there? Also looking for explanations on why there is basically zero aftermarket support... Seems like a company that does after market stuff would have things to support this "long slide" full size pistol by now.