Seems like that would raise the pull weight. I’m sure that’s not the intended purpose of the change though???
I installed one of these in a Gen 5 19x yesterday using the standard dot connector. Initially it was very gritty on take up. Had to do quite a bit of tweaking on the connector and smoothing of contact points. I still have a good bit of contact on the trigger bar against the slide stop and frame but it’s tolerable now. I haven’t measured but I’d guess it’s somewhere around 3 lbs with the silver trigger spring. Reset and function is fine. I’ll be honest, I didn’t care for it initially but after tweaking, greasing contacts points and breaking it in a little, I really like it now.