Small pistol Primers are not dropping out of the Magazine. This is a new XL 750 unit and the magazine tip is still fine, I have been trying on and off for 3 weeks to get this set up.
**I have checked the plastic end on the primer tube on the press to see that it is not damaged, seated correctly, and is the correct tube.
**If I remove the primer magazine from the housing, hold it upright on the bench, and drop one primer down into the magazine, it flows through no problem.
**When I have no primers in the tube, the mechanism cycles as it should and I can see down the tube with a light that the primer cup is indeed in place and ready to receive, so the operating arm and the slide are fine.
**When I send a primer down the magazine inserted in the housing and cycle the press, the primer punch and slide are working fine and the primer does not fall into the primer cup- IT DOES NOT FALL AT ALL. If I tap the magazine housing then the primer will fall out onto the slide so I can sweep it out with a small brush.
**Careful about trying to line up the groove in the magazine holder with the little tab on the magazine and then push down a tiny bit more. WHAT ELSE? Can anyone think I anything else I haven't tried?