SickSilverado

It's a nice trigger. The install wasn't bad. Only thing I really didn't like was that it breaks at a negative angle. I think it has something to do with the sear/reset tab. My little pea brain couldn't work out the math to tune it to my to a 90 degree break.

Oh ok. I thought maybe I did something wrong to end up with the negative break. Glad you're happy with the trigger. I am too, I guess I just need to get used to the break.

Where does your trigger break? 90 degrees or negative? Mine breaks negative and it throws me off a bit. I'm considering going back stock if I can't get the 90* break I want.

How did it turn out?

At the moment, I have the full Henning/EGW combo in a small frame - medium trigger, sear, hammer. It has a short take up, nice firm/defined wall, and a 2lb break. Reset is OK, but could be shorter. My only real issue is that my trigger breaks at a negative vs 90 degree angle. Most likely user error, but that's where I'm at with it. Henning offered to talk me through it over the phone, but I was having embarrassing speech problems at the time so I never took him up on his offer.

Agreed. Awesomeness.

I did polish the factory sear on the sides like you mentioned. That one seemed to stick the most. Thanks for the link. I'll give his methods a try.

I found the problem, but not sure how to fix it. It was like you said, sear spring isn't moving the sear back to the default position. I swapped in i believe my 3rd sear(unica). I noticed all the sears get stuck when pushed i to the default position. Also, all sears are chewed up at the bottom after a few dry fires.

I took out all pretravel just now, still didn't work correctly. I disassembled and the sear is chewed up again. I resurfaced it, then tried again, and its chewed up again. What could be chewing the sear? Hammer is smooth as far as I can see.

I've put maybe 200 rounds through it.

Hello yall. I have a new Defiant Limited Master. I did some polishing and installed the Henning flat trigger kit. I took it to the range and had what seemed like 2 light strikes, but looking back i think the hammer was at half cock. Now at home I've racked the slide several time to find the hammer following. I put the stock trigger back but it still does it. I clearly did something wrong, the under side of the sear face was chewed and beaten to shite. I replaced the sear but no luck. Maybe I have too little pretravel or too little overtravel? Anything else I should look at?

6-40 screws didn't fit for me. Wrong pitch it seems. EDIT: The actual 6-40 screws did fit. Turns out I received ten 6-32 within the bag and the were prettier so I grabbed them first.

I was recently told by a more knowledgeable member that the size is 6-40. So I bought a 50 pack. Should be here Tuesday, so if you haven't reported back by then, I'll post up my results.

Same here. I remember describing this fictional spring to my wife and saying I don't know how I lost it. I was so careful. LOL.

Thank you brother.

What size screws for the RMR to Legion. Having trouble finding the correct ones. Its not M4 70, not 6-32, not m3 50. Any help would be appreciated. Thanks.

My Legion got holster wear the first day I got the holster. CT International holster. I set the retention to just hold the gun if inverted. I plan to send the slide to be cerakoted the same color.