czebin

Are there different models of the Czechmate? I ordered one with the grips like the new TSO and on the CZ website it shows a different version with different grips and no predrilled holes for a *thumb rest [generic]* on the optic mount. Anyone know the differences between these 2 or which one is the newest model?

I appreciate all of the responses. I ended up selling the 3n38 after reading this and got some WAC. I'm going to start there!

Are the 125's ok or would you load 115's?

What would you recommend?

After shooting limited in .40 I ended up buying a CZ Czechmate in 9mm. I am planning on shooting major and have a bunch of 125gr Zero JHP's and 8lbs of VV 3n38. Anyone had success with this combo?

Anyone know if there are any differences in the Mark 7 for the 1050 vs 1100?

Multiple clicks per stroke.

I just purchased a Mark 7 for the 750. I processed 1500rds of .40 and loaded around 100rds. During loading, on the upstroke, I now hear a strange clicking noise from what I assume is the gearbox. It is a new sound and doesn’t seem right. Has anyone experienced this by chance?

Im curious why you don't use the powder sensor?

Thank you everyone for the replies. Last question, should I go another route vs the 750? I just didn't want to spend the extra cash on an Evolution or the toolheads needed for a 1050 for each caliber.

So I can't use a powder sensor unless I use a seater / crimp die, the decap sensor you don't use so all that I need is the bulletsense??

I do not see a swage sense for the 650 / 750. Can you send a link because I am at a loss.

Which sensors would you recommend for the Mark 7?

Is the powder check even important when running automated?

Gotcha, Thanks!

I read that you can use Mr. Bulletfeeder but only on station 3. Powder check is a no-go though.

Im looking to purchase a Mark 7 for my Dillon 750. Are guys using a separate press for load development then running the Mark 7, or is it easy enough to use the Mark 7?