kuletchi1

In my honest opinion since a use .355 and only .355, I'm afraid that if I switch to a bigger size bullet it would change the fit of the barrel and would not be able to go back to .355 after shooting much of the .356. Sent from my SM-N975U using Tapatalk

File the corners of screwdriver and sharpen it up. That's how i do it. Also might want to start using complete jacketed bullets to cut out most of the carbon Sent from my SM-N975U using Tapatalk

I use srp on all my competition loads aside from my revolver where i use federal spp. I also use 5.2 of universal clay on my load with 1.180 oal .419 crimp, 180 gr Montana gold Sent from my SM-N975U using Tapatalk

Saying goodbye to a wonderful person. If you've shot in Norco back in the days, then you know this person. His known to most at the range as Uncle Mike (Mike Agoncillo) and you know how good his bbq on a stick is. Rest in peace my friend, sure was great shooting with you and shooting the breeze Sent from my SM-N975U using Tapatalk

Gun store salesman that has all the guns they sell. I have that, i have this, i have those, etc, etc, etc........... Sent from my SM-N975U using Tapatalk

Let's hear it from all the haters Sent from my SM-N975U using Tapatalk

Went out of business at the beginning of this year, if I'm not mistaken Sent from my SM-N975U using Tapatalk

Thanks Sent from my SM-N975U using Tapatalk

Looking to purchase some extended basepads +0 for my 10 rounders. Most I've seen are for the standard magazine capacities not for the 10 rounders. Basepads are different. Sent from my SM-N975U using Tapatalk

HS6 and AutoComp Sent from my SM-N975U using Tapatalk

On the 9 major its needed due to the amount of powder that needs to burn. Depending on the powder use, i sometimes get unburned powder. Sent from my SM-N975U using Tapatalk

That's what i use for my competition loads all the time. Whether it's for single stack or limited and for my 9 major Sent from my SM-N975U using Tapatalk

Had some older red dots that i sent back due to problems i had with them not functioning properly. They replaced them with new ones without asking. Took just over a week for the whole process Sent from my SM-N975U using Tapatalk

Thanks everyone. I guess i have get the jig and the file out to do it, no way around it. Sent from my SM-N975U using Tapatalk

Been using Winchester srp on my SVI and STI open guns. Have never had any problems. Pf's are 170-172. Same goes with my limited and single stack guns. Sent from my SM-N975U using Tapatalk