Rising Sight

Coated Bullets would probably last a very long time.

Are you sure it has a stock recoil spring?

Dave Sevigny does alright with a Glock. You can't go wrong with a 35. Get a magwell,sights and clean up the trigger.

That match was a blast. It looks like a dot gun won it for the first time this year.

I wonder if crushing your magazines is a wise decision. It looks to me that you could get the same results by placing your mags in a vise. A vise would also have the added benefit of freeing up both of your hands to remove the basepad.

Stefen is to blame. Because of the higher round count.

The pin portion of the firing pin stop broke. I was thinking about grinding off the nub that sticks out,but I am pretty sure that would enter me into open division.

I recently purchase an SP01 and had a slide stop issue. When I do a reload my trigger finger hits the nub that protrudes from my slide stop lever. When I do this my slide stop gets pushed out of the frame slightly and causes a nasty jam. My slide stop eventually broke.Is this a common problem with the SP01's slide stop?

So,where are the local watering holes in Fulton?

I ordered Mec Gar mags......with any luck,common sense will prevail.

I don't think the magazines should even be an issue. All of the major external dimensions of all of those magazines are very similar. The magazine fits in the gun,the gun fits in the box. Is a slightly different basepad design going to cut my reload times in half?

I recently put together a 17 open gun. After shooting Production class mouse fart loads for the last couple of years that comped 9mm definatly gets my attention.

I think I will buy some MecGars for now.

So,it looks like factory 10rd SP01 mags are what I should buy. I would hate to order new mags and have them be illegal in 30 days.

Are the factory mags the only ones that are legal for Production?