Jump to content
Brian Enos's Forums... Maku mozo!

unclerandy

Members
  • Posts

    5
  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • Location
    Southern California
  • Real Name
    Randy

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

unclerandy's Achievements

Looks for Range

Looks for Range (1/11)

  1. I appreciate the advice. It is a very small part and the leg will be less than .250, I'll give it a try when the spring get here. I'll start oversize and finish with a file.
  2. I was concerned this might effect the heat treat.
  3. I'd like some advice on how to cut a 1911 sear spring. I need to make a hand spring for an 1800's spur hammer .22 and intend to use a chopped 1911 flat spring. How would I go about cutting it? I don't have a band saw or scroll saw. I'm not sure if its to hard for a coping or jewelers saw. Wondering if I'll have to anneal it in order to cut and reheat treat?
  4. Thanks for the reply. I should have added from the beginning; I also installed the Cajun Gun Works Defensive Carry Package. That covered the new hammer and adjustable sear. The disconnector is removed.
  5. Hi guys, I’ve searched here and the CZ forum for days but haven’t quite found what I’m looking for. I have a SP-01 manual safety I’m working on. I’d like super clear and detailed instructions on adjusting/tuning the two set screws on my Cajun Gun Works 5SAO trigger. Video would be great but haven’t been able to find one for this. I’m great at following directions and prefer that route over tinkering in ignorance. Thanks
×
×
  • Create New...