jubi351

3.0gr with hi-tek coated 160gr was 138pf in a Gen5 34. I'd start about 2.7 or 2.8. Sorry, this was for 9mm

Generally if they fire on second strike the primers are not seated fully.

Shot over 10k of the green and yellow box Servicios with no failures. Friend of mine has shot over 20k of the white box variants with only a couple light strikes in a Glock.

Agreed

Pretty sure Tyler uses Xtreme 165s. 2.7gr of N320 made 131 in my Tanfo S3 when I tried them.

Jeff just did the same for my Bul

You'll have to get rid of the brass stringers in the die by using a .223 copper bore brush wrapped with a grey scotch brite pad. Put the brush in a drill and run it untill it builds up heat in the die. Then only use a lanolin based lube or it will do it again. Redding performs as well without all the additional steps.

I just use Ginex SPP, Servicios SPP and CCI SPP and do see a lot of yellow corn meal in the barrel but it hasn't caused any problems. I have some magnums, I might try them to see if there is a difference.

This was 9.8 AA7 124PDV2 @1.170. This ammo at Nationals in my Bul with 2 3/16 holes was 171. I would not shoot a level 2 or higher with this load in the MPA, would bump up .1 or so but it's fine for locals.

I have a MPA DS9 with nine holes and it makes 167 power factor with 9.8 AA7 and 124PDV2 bullet. I don't know how they do it but their barrels are fast.

1.165

Bul 5" with 2 3/16 holes, 10.4 AA7 with Berry's 115 HBRN give me 171pf. I would probably start at 10 grains and work up. The MPA barrels I have shot are much faster than my Bul.

Looks like 9x25 Dillon?

Something else to consider, this rate increase may not be the last so lifetime may pay for itself faster than seven years.

Thanks. The bad thing is I use the search function under general reloading which should have checked all sub categories and yielded no results.

Curious if anyone has tried the new bullet feed die from Lee? MSRP of $50 but is listing between $35-$39. Could be an alternative for the DAA if it works with coated... https://leeprecision.com/inline-bullet-feed-35cal

Second that, no issues.

I replace the battery twice a year whether it's my SRO, Holosun or FTP, cheap insurance.

Knife sharpener

Agreed, sear is badly worn.

A This classifier was not used, since the score is more than 20% above class and determined by the data enterer to be invalid. If you believe this score should be counted, please fill this form out. However, because you are not classified in LO is why it accepted it to get your initial 6. Regardless, still awesome job.

Awesome that they accepted it. Usually they won't because of how much higher it is than your current classification. Great job!

Weak thumb.

Are you possibly flaring the case too much? I just loaded 2k and there is hardly any brass shavings in my die.