Jump to content
Brian Enos's Forums... Maku mozo!

Lee64

Members
  • Posts

    12
  • Joined

  • Last visited

Everything posted by Lee64

  1. Tacswap (dot com) is pretty active, but requires a subscription.
  2. Lee64

    Weird RDS issue

    The two posts above reflect my experience with a C-More RTS sight. I went thru two CZC Shadow 1 aluminum RDS plates that wouldn't hold for 3 stages, even with red locktite. I switched out with a steel RDS plate and blue locktite and the screws have held for two matches.
  3. I’ve been shooting the 135 TCs for a couple years now. Currently I load with 3.6g VV n320 to an OAL of 1.115” for an average PF of 129. I have used 3.5g of W231 as well for a similar PF in my CZ Shadow.
  4. I tried going the HS-6 route at first, but at minor power factor it was really dirty. I had partially burnt grains in my sear cage and frame and had to clean my SP-01 every range trip. I use Win231/HP-38 and N320 now with much better results, cleaner and less sparky.
  5. One trick I found is once you have the trigger bar spring in place and snugged down, back off the screw barely enough to get the spring ends to float just off the wall of the frame. The reasoning is when you tighten it the spring naturally rotates into the left wall, and will try to jump the tracks during shooting sessions. Once adjusted, If you invert the frame you can see the spring riding easily in the grooves of the trigger bar. Then you can adjust the vertical position of the legs as seen in the video.
  6. Depends on the gun. I replaced the sights on my 1911/GSR yesterday with Dawson sights. Their website redirects you from the Sig to the Novac cut sights. It took about an hour to fit the new sight set.
  7. Picked up 4# from Natchezss dot com last night. Limit was 1 jug, came to $148 with shipping and hazmat
  8. Lee64

    Blue Bullets

    Well, supply chain must be getting better. Ordered 1100 Round Box 9mm 135 Gr TC on August 14th, just got a shipping notification today. Approximately 5 weeks.
  9. With a maximum OAL of 1.149” in your barrel with your bullets, less a safety margin of 0.015 gives 1.134”. 1.130” is what I load to in my SP-01 which should have the same leade as an S2. I haven’t had any feed or ejection issues at this length.
  10. I'm settled on 3.8 grains of W231 under a BB 135 TC.
  11. This is the best explanation on determining OAL I found. It deals with the CZ barrel specifically, but applies to all barrels. The author is very active and helpful. Determine max OAL
  12. I just got a used SP-01 that came with 2 sets. I didn’t like the CZ thin aluminum as much as the stock grips. Thinking about trading for LOK Palm Swell Bogies? Any experiences with those grips?
×
×
  • Create New...