I’ve had the Rollsizer decapper for almost a month now ! Absolute LOVE IT! Also have the Rollsizer and they are set up side by side and I use the Dillon casefeeder set up on the Rollsizer. When using the decapper I turn the feeder slightly and connect to the decapper. I done well over 25k with the ONLY ISSUE being the pin getting stuck in the NORMA small flash hole brass. Reverse up, needle nose players on the stuck case, couple taps with a small hammer and start again
averaging about 6k pieces / hr!!!!
Just wondering if my loads might be off a little for 380. I seem to get some un-burned powder everytime with my SIG238.
I am using the xtreme 100gn plated and mostly Blazer range pickup brass. I am using WIN231 powder with a load of 3.1-2gn and OAL of .974-75 and crimped to .374-5 . All loaded on a XL650 and each round #'s verified for OAL/crimp and weight. I do not have, or access to a chronograph but the accuracy is good (Usually a little less than 3" at 10 yards with 5 rd.groups.
Anyone with suggestions would be greatly appreciated.
I decided to start at 5.6 and will work up 40rounds and increase .2 to 6.0. Sure go through a lot of powder compared to the Bullseye that I was using. Wife and I will test this coming Sunday with SIG 365, SIG 320, SIG 229, CZ P10, Berretta 92,
I can’t seem to find much data for Unique powder with Extreme 115 plated round nose for 9mm. Anyone here using Unique powder for 115gn 9mm? I have been using Bullseye with a 4.4 load with good results but wanted to try other powders to compare.