Jump to content
Brian Enos's Forums... Maku mozo!

ABCDM

Members
  • Posts

    10
  • Joined

  • Last visited

Everything posted by ABCDM

  1. "THE PHOTO SHOWN IS A STOCK DILLON PHOTO. OUR UPGRADE HAS NOTHING TO DO WITH THE HOUSING. " That case deflector is junk. Just pull it off.
  2. With the feeder upgrade, you may have to clean up some stuff on the Dillon bowl itself to keep it from jamming. Most of it comes from the exit itself having a lot of flash on it from the injection mold. It makes the case rise up just a bit which allows the plate to carry them too far and they get caught on the other side, especially if the plate has some old case lube residue in the pockets.
  3. The mods are very simple. 1. use a file to roll the flash and lip down on the exit area of the bowl. The injection mold leaves material there that makes it act like a ramp so the cases lift up when they should be falling. They are up long enough for the rotation to carry them over to the far side and jam them in some cases. 2. clean the pockets of the shell plate occasionally. Case lube makes them very sticky and they will hold the case just a slight bit..combined with the ramping from 1 and you can see the issue. 3. a zip tie around the bowl wall at the exit, nipped just enough to leave a small bit sticking out, helps kick the cases off the plate so they aren't as effected by 1 and 2 above. You will will have to find the best spot based on the cases you are running. All of these together pretty much eliminate the jamming and the brass waterfall (the cases don't carry too far and bounce in the funnel.
  4. The frame, the elliptical, the indexing system, etc...there are a lot of changes.
  5. While they look the same, the 1100 is not just an RL1050 with those parts. Major work was done on several other things, like the actual elliptical.
  6. https://www.facebook.com/ImmortoBot/videos/373854110097989/
  7. Looks like ImmortoBot did some videos at SHOT https://www.facebook.com/ImmortoBot/videos/1531059850370906/ https://www.facebook.com/ImmortoBot/videos/373854110097989/
  8. The Immortobot prices for the small unit is the same as the Rollsizer prices. The shipping from Virginia is going to be cheaper than from Australia.
  9. The manual rollsizer will take a power drill. There is also a DC motor version as well. The small units will only do pistol, so if rifle is something you are looking at, then you are going to have to go big. None of have shipped to the US yet, but they are getting very close.
×
×
  • Create New...