Jump to content
Brian Enos's Forums... Maku mozo!

AnonymousCitizen

Members
  • Content Count

    5
  • Joined

  • Last visited

About AnonymousCitizen

  • Rank
    Looks for Range

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. All done ! Thanks for all the guidance and suggestions. I bought some replacement parts from Cajun (floating trigger pin, spacer to replace the lifter, and a firing pin retaining pin), a Single Action trigger from CZ (CGWs was out of stock), Hogue wrap around finger groove grips, a front sight from Hiviz, some additional Dremel polishing bits, and I got to work. I found a few dis-assembly \ re-assembly videos on Youtube that helped me along. One thing that I found kind of odd, was that little pin that's used to retain the hammer pin - I understand what it's doing and why it's necessary, but it just looks kind of out of place to me.
  2. Thanks again - this gun is just gonna be a range gun, for now - I'm leaning towards just modifying the lifter, polishing some of the internals, and calling it good.
  3. Thanks - I'd seen that link and I will move it to the top of my to do list. Any thoughts taking the lifter out and replacing it with the spacer, or removing the lifter AND the existing CZ-75B sear, and replacing both of those parts with a CZ-75 sear??
  4. Thanks very much guys - being relatively new to these guns, I don't know a lot about what's normal - I appreciate the enlightenment! I am thinking about removing the firing pin block stop, spring, and lifter, and putting in one of those spacers (https://czcustom.com/cz-parts-all/fire-control/cz-75b-firing-pin-lifter-spacer.html). I've done the same thing on all of my Series 80 1911s - I just don't like the blocks. I'm guessing that the CZs are relatively similar to the 1911s as far as the function of the firing pin block and that reliability won't be compromised with the block removed and the spacer in place? The complexity of putting in the spacer looks to be a bit more with the CZ, versus the 1911, but that's why Al Gore invented the internet, and YouTube, too, I guess.
  5. I have a glossy stainless CZ 75 B that is trying to convince me to give up Glocks - first time at the range yesterday with the CZ and my groupings were far better than anything I ever get with any of my Glocks. First two things I'm gonna do are to put a more visible sight on it, and I like the Hogue wrap-around grips. As I'm new to this gun and learning about it, at this point, I have a couple of questions, with more to follow, I'm sure: with the slide off the gun, is the Firing Pin Block Stop supposed to be fully extended so it's even with the raised section in the middle of the underside of the slide? Mine is slightly depressed and it doesn't "look right" compared to other guns I have with this kind of firing pin block - also, the firing pin also seems a lot harder to push forward when the firing pin block is pushed in than other similar pistols I have that have firing pin blocks - like the spring is a lot stronger. with the slide off and the barrel and recoil spring out, there's a fair amount of resistance where the bottom of the slide first engages with the two "nubs" on the top of the trigger bar, and then moving the slide back further there's even more resistance when the slide is moving back to just before and after where the dis-assembly notches line up - is this normal?
×
×
  • Create New...