4thquarter

Is this a known issue? Have many others had this problem? I just ordered a Kidd trigger for my X-Ring receiver

Bill did have a solution. It is not advertised but it is called the xrest on his website. Thank you

What thumb rest is this, I cannot find any from Strickland, I found the Striplin one for a mark4 22/45. Will that fit the mark3 frame 22/45?

Sorry I should have specified. This is a new build with a blank barrel. I am reaming the chamber to length, I want to load out to about 1.16 or so. I have a dummy round and will keep checking as I go but want to check and see what the actual measurement calls for. I understand cases are going to vary and I want to allow for the differences.

I am ready to ream my 9mm barrel and am having trouble finding the exact dimensions of the measurement from the barrel hood to the ridge. Is it .754”. What are most open 9mm builds set too?

I contacted them here, they were great to work with. www.blacknitride.com 330-745-3075 (PHONE) 330-745-3160 (FAX)

Send it to black nitrite, They are fast and reasonably priced, they do have a minimum order so if you can find a couple guys that want to refinish their guns it works best to send at least two or three off at once.

Slow and steady, mark the fitting pads with a blue marker, dry fit then stone/file repeat.....

^ this

Good to know, thanks Ssanders.