joshbracken

Kamber: Thanks for your posts. Look forward to reading more of your posts as you go along. I am interested in doing the same thing. Buying a 3D printer and also a Mark 7 Evo without the case feeder or bullet feeder and making my own Sent from my iPhone using Tapatalk Pro

YAAAAS! It works! Sent from my iPhone using Tapatalk Pro

I am still having the issue. Sent from my iPhone using Tapatalk Pro

Still have the same issue. Sent from my iPhone using Tapatalk Pro

I have the same issue. I first started using Tapatalk a few months ago. Can’t load a page other than the first page. I try to scroll down and only get the loading symbol... and nothing happens. This happens on any section of the forum. I tried the clear cache idea, which didn’t help. Using a brand new iPhone XR.

Galloway Precision sells recoils springs as well as trigger kits, mag wells, mag extensions for the SR9. I used an SR9 as my first gun in competition with a lot of those upgrades and it worked well. However when I changed the recoil spring to a lighter spring it resulted in failure to feed issues. I ended up going back to the stock spring. Sent from my iPhone using Tapatalk

I’d like to see a video on it marking inside the rim of the case. That is my preferred marking method. The guy mentions that it is possible in one of the videos but never shows it. Sent from my iPhone using Tapatalk

I had the same issue. I was new to 2011/1911s and after I installed the new Nitro Fin the slide would bind and not go fully forward into battery. It turns out that the barrel lockup is very sensitive to the slide lock pin diameter. Even if the diameter of the pin was off by 1 or 2 thousandths it would bind. After I sanded the diameter down to exactly the same diameter as the old slide lock pin it worked perfectly. What worked well for me was holding the NitroFin in a vice and using a thin strip of sandpaper that I could work back and forth to remove material slowly. The vice helped so I could apply some pressure with the sandpaper.