Hey hey all. First let me say, what a great informative resource for the cz guys. Coming over from single stack 1911s to the shadow 2, the cz’s are a joy to shoot.
New shadow 2 I’ve Flat blocked and polished to a mirror finish. Have not made any spring changes yet as I’m still getting the hang of the hinge type trigger. Im curious about the double action end of this. I hope this isn’t outside the “101” part. I’ve noticed that my double action break is breaking a bit after my single action break. (Or SA is breaking before depending on which way you look at it) This causes a excessive amount of overtravel in the single action, somewhere around a few mm. If you were to adjust the over travel screw down to make the SA overtravel less it will not be able to break I’m DA. What I would like to do is bring both the SA break and DA break closer together. Either by making the DA break earlier or SA break later. This would allow me to set the overtravel screw for both actions with the smallest overtravel. I do understand there’s a trade off with the reset. I do see from the photos of the trigger bar and sear for the DA / SA break. I’m just not sure if bringing them closer will effect the timing elsewhere. What would be the best way to go about achieving this?
Thanks in advance.
PS ~ sry for the long winded post.