Is there anyone having 9 mm brass sizing issues? Before this gets to crazy let me explain. I have been reloading for many years I have been shooting open and switched to minor for a break. I am having problems with my 124 RMR JHP falling into the case before get a chance to seat them.
I am loading on 1050s, I tumble and dry my brass, pre lube before sizing, using dillion sizing die, MR bullet feeder funnel expander die set at outside flare is .377 .378 just enough for the bullet not to fall off before seating, and finally Mighty taper crimp. I know that 9s are tapered my inside is is roughly .352 .353. My bullets are .355. A lot of the loaded bullets fall out when I case gage them. Also I can push them back with very little force. I am using the same set up with my open ammo and no issues. My main concern is bullet set back and having a blow up.