Jump to content
Brian Enos's Forums... Maku mozo!

L3324temp

Classifieds
  • Content Count

    534
  • Joined

  • Last visited

About L3324temp

  • Rank
    Calls Shots

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. 124g Nato ammo seems quite stout. I have never chrono’d it but it recoils noticeably harder than your average 9mm ammo (not scientific, I know). Sent from my iPhone using Tapatalk
  2. I cannot. I bought n320 because of the feedback here. There was no difference from tight-group for me. I can tell the difference with bullet weights though. Sent from my iPhone using Tapatalk
  3. Dawson. My Trojan has over 10k and has been flawless. Sent from my iPhone using Tapatalk
  4. Agree. Far better than any gun oil I have used. Sent from my iPhone using Tapatalk
  5. No. I have never had a need to do this. Sent from my iPhone using Tapatalk
  6. I have done this but I feed them manually into station 4. It goes fast. Sent from my iPhone using Tapatalk
  7. We maybe have 5 who shoot 40 major in limited. It certainly seems like there is a major shift to limited minor taking place. With the way USPSA likes to change rules for no reason I would not be surprised to see PF eliminated from limited. Sent from my iPhone using Tapatalk
  8. That is what the guns needs IMO. I got to handle one last week and I found the grip not nearly grippy enough for me. Sent from my iPhone using Tapatalk
  9. My Atlas has been flawless since I shortened my OAL on my reloads. If using coated Bullets the OAL needs to be short or it will not fully go to battery 100% of the time. Using jacketed or played allows the longer OALs. But since it runs 100% near factory OAL with coated there is no reason to go longer for me. The fit and quality of the finish is also top quality. Sent from my iPhone using Tapatalk
  10. Once you do it the first time it is easy after that. The calibers you mention are all small primer so this also cuts out a few steps. After a few times you can knock the conversion out in about 5min each. Certainly less than 10. Sent from my iPhone using Tapatalk
  11. I use a coffee can full at a time for the brass. Sent from my iPhone using Tapatalk
  12. I would agree this is the most likely cause. Sent from my iPhone using Tapatalk
  13. Use a punch to put a small dimple where you need the hole to be before drilling. Also be sure you have the post laying horizontally on the bench. Trying to drill it while mounted vertically on the press will make proper leverage difficult. A fresh drill but also helps. Sent from my iPhone using Tapatalk
  14. I agree. Should be a quick and easy fix. Sent from my iPhone using Tapatalk
×
×
  • Create New...