Jump to content
Brian Enos's Forums... Maku mozo!

ninjaboot

Classified
  • Posts

    56
  • Joined

  • Last visited

Posts posted by ninjaboot

  1. When I first started out I used empty mags and felt good with my reloads. During matches not so much. I started dry firing with loaded mags to capacity (depending on division I'm shooting) by loading up dummy rounds with no powder or  primers that I keep in a separate container. I think it makes a big difference. 

  2. So I got my 320 back a bit ago from Sig . I was using a 320x flat trigger in before the upgrade. I swapped the stock curved one before sending out. Last night I finally started dry firing again with it and really not happy with the upgraded curved trigger feel.  I swapped the pre upgrade 320x flat trigger in and it felt more to my liking. Any reason I can't run that shoe in there? I haven't  test fired it yet but so far it seems like its functioning fine.  I understand about the weight mass reduction of the newer trigger shoes. Anyone else running pre upgrade trigger shoes in a post upgrade guns?

  3. 3 hours ago, Bkreutz said:

    There's one thing that I haven't seen mentioned here (or maybe I'm blind, that's possible too 🙄) I've had the ejector wire (the one that guides the finished round into the bin) work it's way up and that will prevent the case from getting completely inserted into station 1, I use a flat blade screwdriver to push the back end of this wire all the way down into the hole.

    Haha! Ive had that happen to me as well and forgot to mention that! After switching to a shell plate bearing it took some ejector wire massaging. Good call

  4. I had this same problem with cases catching on the resizing die. I cleaned the shell slider and indeed it had a burr in it from a double feed (Again same issue as you with the plastic case feeder insert). That fixed most of the issues but I also found the case wasn't getting seated far enough into the shell plate. I adjusted it to go in farther just a very very small amount and that's all it took. I haven't had a issue in the last 5k Ive loaded.

  5. Ive tried it. It's OK.  I must have had a weird batch or something cause my deviations were all over the place. I started loading .40 with Titegroup, tried N320, and just recently have been using HP38. I know its pretty close / same as W231. I didn't find much difference between the 3 other than Titegroup being the dirtiest. For me I prob wouldn't buy it again. 

  6. I also I have a very low basement ceiling height. Due to my bench height my case feeder is 3" below the bottom of the rafters. I load the case feeder in between the rafters. Being that its low I have a bar type stool that I kind of halfway sit on it. I have one foot on the ground and that allows me to seat primers good. Im on my feet all day so sitting is nice. 

×
×
  • Create New...