I have an accushadow that I decided to try the CGW reach reduction kit in. I got it installed without much trouble and it felt great with about a 6 ounce reduction in DA trigger pull weight. I'm running a 10 lb main spring. I noticed that the hammer doesn't seem to cock back as far with the CGW kit in DA it as it did with the original parts. I does drop fully. I took it to the range to function test and had many light strikes with CCI primers and no problems with Federal primers. The light strikes were only on the DA press. I took a look at some of my fellow competitor's guns with the CGW reach reduction kit at the last match and indeed their hammers are cocking back further in DA than mine does. I wouldn't care too much if I had an unlimited supply of Federal primers but these days who does? CCI for practice, Federal for matches.
From what I can tell I need to delay the timing so that the DA press brings the hammer back further before the sear breaks and drops the hammer? My understanding is that I need to remove a very small amount of material from the bottom of the sear cage to make this happen? The DA press breaks very closely to where the single action press does. Maybe a a millimeter sooner but not by much. Sure, I could put a heavier mainspring in but that would kind of defeat the purpose. Just want to get some input from more knowledgeable folks before I do anything. Thanks!