slimm609

N320 Titegroup WST

welcome. Add this one to your addiction list as well!

very nice. all 3 look awesome. what sight mount is that on the SV?

The gun is the least important part, but sticking with the same gun is very important. Learning and knowing exactly how your gun fires, recoils, etc is important and will only come with practice with that specific gun. Get a gun you like and stick with it. Shoot the gun for a while before you go and change anything on. Once you know the gun inside out, then you will know what you want to upgrade.

If you want to do pass through get the GRX and a single stage press. The Lee die is not made for pass through. The bottom is sized properly but I doubt they do the level of precision on the top that they do on the bottom. It's probably not far off but I doubt it's as consistent as the sizing part of the die

I have used the Redding GRX followed by the Lee u-die and have had very good results. The u-die or the grx by itself are both great but with both together I get almost no issues with barrel or case guage.

Blue bullets have been awesome. If you are not sure or a small quantity of a few different bullets and inspect, measure and load a few of each. See what you like and what works best for you. For coated blue, bayou or SNS and you really can't go wrong

Both are great but the Dawson are my preference. I like the grips on the Dawson base pads. I feel like I get a better grip on them

That doesn't seem like a bad price. 25lb is a very good size tumbler for wet tumbling. Gonna require a large amount of stainless steel media

On most forums that accept donations normally give some small little benefit. (e.g. a special category, a different color name, access to a donation only forum section, etc). Just a thought.

STI has awesome support. Hope they get you all fixed up quickly.

Play around with how long you tumble them. I always deprime the brass before wet tumbling so it cleans the primer pocket out really well.

That could have ended very badly!

You need to get a good clear coat or it will come off fairly easy from what I have seen. A friend had it done and it didn't hold up to well by itself

Then you are good to go. That's exactly what you want