vincentfabi

thats why there are fewer and fewer stores around with mark up like that its no wonder gun shops go out of business. the margins are so close why would you want to be a dealer.

Don't you think if your running a 40 in minor that you would want to run a spring that comes in the lim pro 9 like a ten pounder. Your shooting minor out of a gun that is set for 170pf what spring is set for 130 well that would be 9mm. 10 lb and your good.

Well I can only comment on my brand new sti edge out of the box simply will not run bought six brand new factory sti 140mm mags none of them work can't even load rounds into the mags the 126 mm mag appears to work but then theres the barrel take a 1.185 oal reload that drops in perfect to a case gauge will not drop in the sti barrel drop a factory 180 does not drop in gets about half way.. so my opinion sti guns from the factory are slapped together and do not function once tuned by a good gun smith then your good to go. dropping mine off to tight group firearms tomorrow for some needed loving... if i were to do it again brazos it is...

I successfully installed a Titan hammer in one of my stock 2 and a extreme delta hammer in the other, the extreme delta has a nicer single action in my opinion to be honest i almost prefer the stock two piece sear and stock hammer to the one piece sear and extreme parts, i have not broke it in yet so i will report back later. i also only fit one with the proper safety function and may leave the other where the safety does not engage as i never use it and i like the fact that i can never engage it when i do not intend to. more to come after some range time.

Other then being clear coated I don't think anything.

Dawson sight set screw needs to go in from the bottom of the sight run it up flush and then install and lock it down.

are there any visual instruction on properly fitting a new hammer to safety. I searched hi and low on the inter web to no avail. I have a idea of what is needed based on all the comments above, i just want to see it before i botch anything up.. thanks vinny

greg cote

Hello, I have been trolling the board left and right but my brain works better with pictures i guess. my question is I have a new Delta extreme hammer and am trying to figure out what exactly i need to do to fit this thing. Erics instructions shows a picture of the leg that i am assuming i take material off of. im just not sure where. is it the tip of the leg the sides of the leg. thank you in advance for any help.