PatriotDefense

Not exactly, we're focusing on getting the Small Frame and CZ models out before we release a smaller profile palm swell grip..... all great things come in time

This man speaks the truth, the amount of gas the barrel and brake bleed from a 9mm is outragous. You really have to run super hot loads to make PF....... I have a 38SC V12 and it's about 8-9PF below what a comparable open gun with out the Popple holes shoot with the same load.

Blue magic works well....

we should have those out to you asap

Those curves.......

Sweet video Memphis..... I may need you to do Photo shoots for everything

Unless your rolling with all federals and a 10lb hammer spring you wont have to worry about a sub 2lb SA pull. I think on average you'll see a 2.5-3.5lb SA range which you'll find to be just right once you get to learn a DA/SA gun. It takes a bit of time to move from a striker fired to a DA/SA platform but with a little dry fire you'll learn to love it. I hate to rain on your parade but the factory left the gun far from "Xtreme" and taken care of. Yes the majority of the parts are there, but so is the stacking and zipper feeling in the trigger pulls. Do your self a favor and take the time to polish the internals, you'll be glad you did once your complete.

We should have an EAA order coming by weeks end or beginning of next week.

glad you tried it out and it sounds like it worked out great for ya!

We fit the safeties especially when folks buy the single sided, it's the less costly part.

This is true, i can put some numbers out this afternoon on frame dimensions of the two. Probably the only difference would be the large frames seem to have a raised front and rear back strap that have the checkering cut into them, where as the small frame (at least the one we have) has the checkering cut into the frame. So maybe 1/16th of an inch front and back difference..

Incorrect......... Other wise i wouldn't have just spent a week of my life modeling up Palm Swell small frame grips.

Memphis is correct, ITAR allows us to ship parts and accessories out of the US...... baby steps.....

We've heard this rumor as well...........

This was actually JoAnna....... but ill be sure to tell Joe that you get a warm and fuzzy when he post

Polishing all the pins, and pin holes will probably get you to the 6lb range your looking for.

i don't know if it will or not, never messed with an OEM one besides throwing them in the trash can......

no, we would need the pistol in order for this to work.

Sounds like you have an unlucky Lim-Pro that's going to require a bit of material to be removed. Sand paper more than likely will make you want to throw the thing away before you actually get it fitted. Remember its a hardened piece of metal so going to the dremel will shave hours of time. Just go slow and keep the cut straight.... your on the right track

can you post a pic of what area your hitting on the BOLO......

glad to see it helping some of you guys out.......

Just a few passes with a file won't hurt anything........

Don't be scared....... turn that dremel up

Within .003"...... probably time to get your calipers calibrated..... but close enough for us to do what we're looking for.

That works too, don't forget to polish