mustbeme

I just bought a complete Eliasson rear sight and some other small bits for a vintage Millett Gold Cup sight. There are some loose parts on gunbroker and maybe ebay. springs, rolls pins etc. 6-48 are common scope base screws. I have a pile of various Weaver, torx, and fillister head 6-48s if I can help.

Perhaps a thread resurrection here. I am looking at a Caspian gun that has a Caspian Upper and Lower, with a corbon 400 barrel in it. It has three or 4 Caspian high caps, bomar/fiber optic sights. Anyone know who may have put together a 400 corbon factory looking wide body? Also, there are some solid film lubricants (SFL) products that spray on an dry like Teflon. I just saw a new one at Grainger. These are pretty slick and don't collect a lot of fouling and debris.

Get a set of roll pin punches, vice blocks, best combo wrench you can find (I picked up a heavy DPMS wrench somewhere along the way) Mask off the area when putting the bolt release control and driving the tiny roll pin in. Easy to scratch the receiver with your tool in that area.

I tried tuning my own trigger, achieving mediocre results, winding up with extra big name springs, disconnectors and such then feeling a crisp 2lb trigger from a gunsmith. Then you'll want to minimize the take-up (pre-travel)...Good journey but I realized that I value the destination much more in this case.

I bet those cost hundreds

Hi temp disc brake grease Because I have a big ass can of it