GB3

Pretty easy. I had to remove very little material on the shoe. It almost dropped right in.

Right on. Thanks for the heads up!

Does anyone know how how much material has to be removed from an X5 slide to mount a Romeo 3? I've looked all over and can't figure out what it takes to get a Romeo 3 mounted directly to the slide.

I like to use an old hotel key card to pry on the safety. The plastic doesn't Mar the finish and they're generally stiff enough to exert the force needed to pop the joint apart.

Does anybody know if these new mags fit the gauge with aftermarket basepads? More specifically, 140mm with 4g TTI basepads.

Well, I got this fit together. It was harder to keep the surfaces true on the barrel hood than I anticipated. It fits fairly tight, so I think it'll be alright. I'll probably call it good for tonight and tackle the slide/frame tomorrow night.

Today is a very special day. All of my big parts are here. Now I can start fitting it all together. I cheated and picked up a slide from Brazos. I'm not sure if what I'm doing qualifies as gunsmithing, maybe gun-assembling or gun-fitting? I don't have the tooling, skill or knowledge to hang with the machining that you boys are cranking out. Thanks for not banning me from this thread yet!

I haven't fitted the slide to the frame yet. As long as I don't have to take too much off the deck of the frame in that process, I think I'll be alright. If I need to take more than a couple thou off, I figure the ejector will drop down too far and the ejector pin notch will have to be re-drilled. That might turn the drilled notch into more of a slot, leaving the ejector to slop up and down on the ejector pin. Potentially.

I pulled a set off the prize table and now I'm debating buying the SP-01 to go with them, since they are so highly regarded. They're also 20% of the cost of the pistol, so I'm pretty sure I can convince myself I'm getting some sort of discount and/or deal.

Speaking of impatience, I'm pretty sure I pooched my ejector by installing it a little prematurely.

This is a project I picked up from the classifieds. Finished up everything I can till I get a slide, barrel, ect. I planned on spreading this build over the fall/winter. But, it's looking like impatience is gonna start putting a dent in my wallet here shortly.

Right on! Thanks for the input, guys!

Has anybody tried the new-ish Henning aluminum grips for the SP-01/Shadow 2? Any thoughts or opinions? Thanks!

VZs look cool and are super grippy, but they are heavier than one would think. If your Single Stack gun is close to making weight, it could put you over.

Not that this was your problem, but, I've had a grip frame bushing not fully seated cause certain magazines to seat hard and not drop properly.