Polymer

Is there such a thing as a low profile slide stop pin?

My mistake...i was looking at 0.090 width and 0.150 was the shortest in that width.

They make one that short? They didn't have that when i bought their front sight for my stock 2

They make one that short? They didn't have that when i bought their front sight for my stock 2

They make one that short? They didn't have that when i bought their front sight for my stock 2

Ream it. Contact Beven Gram at Grams Engineering. $29 and best thing I ever did to my CZs and Tanfos.

TTI stippling is typically rougher than everyone else's stippling, they do a great job. They would be the one if I was to lean towards stippling. SC is like skateboard tape, much more rough than stippling especially if you choose a courser grit. It all comes down to your preference.

Ah, small world! If I remember correctly....chronoed at both around sunny 70 deg and 90deg, very similar velocity.

I chronoed that load in both a sp-01 and Glock 34...very close in velocity.

BBI 147 gr Titegroup 2.9 gr 1.085 PF approx 133

Thanks you two for helping answer questions, I've learned a lot from you two on other threads as well. I am starting to work on my Stock 2 with all the parts from PD, I just want to make sure everything is done perfectly. I guess with the bolo I'll keep the stock trigger plunger spring and stock sear spring. What about the extended firing pin block spring and trigger return spring?

Bolo likes stiffer plunger spring....you are referring to the trigger plunger spring right? What happens with the henning reduced power spring?

Search and read everything on the thread "Tanfoglio Bible". Call and buy all your parts from Patriot Defense. They are super nice and knowledgeable. They helped me out tons and I'm in process of completely transforming my Stock 2. Once done, I'm posting all my progress and parts on here and another thread.

I have been contemplating the hollowing out the part of grip by magazine release. Would altering the grips this way be production legal?

I'm going the diy route. I've been reading on here as much as I can, talked to a fellow tanfo shooter at local match, and patriot defense. PD really helped me on spring selection, great company. Question, why are people choosing the xtreme firing pin over the gen 5 henning? Both need the extended firing pin safety block correct?

Thanks. I have been following up on your bolo discussion and recommendations. I know the bolo will not work with gunsmith hacks like you mentioned from talking to several.

I've been studying that quite a bit. Thanks for the effort you put into that thread.

Thanks for the list.

Debating whether to do my own work or send out stock 2 for a trigger job from someone more experienced. Anyone have personal experience with either Jim Bodkin or Jim Jones? What was the outcome after the work? Appears that Bodkin modifies most of the stock parts with his trigger job, whereas Jones installs all xtreme parts and then custom fits everything.

I ordered from him about 3 months ago

So what was the install issue?

I remember you saying from other threads you run a 6 pound one. You're by far the lightest of anyone. Have you tried multiple weights and that's your preference?

What is consensus on stock 2 recoil spring weight with 147 gr at around 130-135 power factor? I just purchased a stock 2 and have found there are quite a bit of choices/opinions.

Thanks!

I noticed there are 3 options for hardware spacer size. What is everyone using? I'm confused which to choose for a bladetech holster, Glock 34, production.