grandpa

I recently purchased a FX-9, and have loved it. But, I wanted to add my Magpul B.A.D. lever to aid in quicker and easier bolt release, but found it will not fit. Has anyone found any bolt release levers or mechanisms to use in place of the factory one that can be used from the right side (ambidextrous bolt release)?

I recently purchased a FX-9, and have loved it. But, I wanted to add my Magpul B.A.D. lever to aid in quicker and easier bolt release, but found it will not fit. Has anyone found any bolt release levers or mechanisms to use in place of the factory one that can be used from the right side (ambidextrous bolt release)?

I have been using it with 9 mm guns. I have a S&W M&P 9 and a Ruger SR9c. With Frontier 124gr CMJ and Berry's 124gr. FMJ, I began using the loads that they published on their site and paperwork, but that did not work very well at all. In order to get the S&W M&P 9 to work and cycle properly, I have had to increase the powder load to 4.6gr. The Ruger SR9c works OK with 4.3gr, but not any lower. I am about to change to Berry's 115gr. FMJ, and will have to start guessing all over again. I wish they had more extensive load data available.