Jump to content
Brian Enos's Forums... Maku mozo!

hammerspring

Members
  • Posts

    35
  • Joined

  • Last visited

Everything posted by hammerspring

  1. Steel Challenge all eight stages
  2. Sorry Warren, I should have looked a little closer before requesting a picture of the mag well.
  3. Warren can you post a picture of your extended mag well for going prone for a 1911 single stack . Do you make a extended mag base pad to use with the mag well? Mike McDowell
  4. Mike if you are interested we need to talk i am also interested to see what this might be, i am checking to see what there longest shot will be. I just seen the challenge at Toms in April, sounds good.
  5. I have a couple of those and afraid that would be the answer. Thanks for the reply.
  6. What is the best way to remove lead buildup from your comp, besides not shooting lead tipped bullets.
  7. Mike it seems to work for me, I tried it with my strong hand and it is slower by quite a bit. Weak hand takes a lot of practice. You should spend most of your time with the long range stuff, other wise i will never beat you.
  8. Welcome Dwain, what Bill said be very careful what you ask for.
  9. Pickaway County Sportsman's Inc, they are located in Circleville 1st Saturday USPSA, 2nd Sat IDPA, 3rd Steel 4th Action Pistol. The web site has all the info you will need.Bad spelling on the first post.
  10. Pickax County Sportsman's Inc, they are located in Circlet. 1st Saturday USPSA, 2nd Sat IDPA, 3rd Steel 4th Action Pistol. The web site has all the info you will need.
  11. I also went with Wilson mags, pricey but worth every penny.
  12. I just went through this very thing with a 70 series colt in 9mm. The gun was about 98 % so i changed the mainspring to 17 lb with a 7 lb recoil spring and it runs 100% PF is 133. Load is 121 Gr.MG with 4.4 grs of 7625. Gun has a 1 port comp.
  13. Mike whats the longest shot? I am planning on shooting this, what time do you plan on shooting, sign me up on your squad.
  14. have you tried the mainspring? my 9X19 was sporadic even with the 7# until i dropped the mainspring down to 16-17 lbs. it wont fire for me at 15. I also had to lighten my slide when I put a comp on it to get it to run right. BTW, I run roughly 138 pf I finally received my main springs, changed it out to a 17 lb with a new uncut 7lb recoil and new firing pin spring went to the range and put 100 rounds through it with out any problems. It does not seems to have any more recoil than before. I believe i will try it with a 8lb recoil spring just to see if it will run. Thanks for the advise.
  15. I have not but will do so and see if that gives me 100%, Thanks for the info.
  16. I have a 9mm colt that i made in too a cup gun. I am running 133 pf which is very accurate and i would like to keep. The gun runs about 98%, i am running a wolf 7# recoil spring with four coils cut off. Using a uncut 7# spring it runs about 60% . I can not find anything lighter, where do i go from here? Lighten the slide?
  17. Prayers sent, know that he is in a better place.
  18. Welcome Russell + 1 on what Flying 40 said.
  19. Way to go Ed, i see you are still traveling to shoot these matches. Hope to see you at Roundtown this spring.
  20. I should not have read that this early.
  21. has not set their status

  22. Learn to use the time allowed. This and trigger control has helped the most.
×
×
  • Create New...