stiblaster

I believe the Magpul 12 round mags keep you in compliance. They have a slightly shorter extension.

I just encountered the Norma brass with small flash hole. What a pain. I toss every one I see now.

I got some of these. They seem to work fine. https://www.ebay.com/itm/Replacement-Sig-Sauer-P250-9MM-Magazine-Spring-2-Pack-Mag-Springs/273612469536?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

I've had Dawsons on most of my other pistols, and like them a lot. That's what I decided to order for the P320.

Anyone using the Trijicon fiber optic sights on their P320?https://www.trijicon.com/na_en/produ...uct1.php?id=FS

Is this just a 9mm problem, or has this been reported with other calibers?

My P320 .40 caliber doesn’t have nearly as much case exposed as that. Mine is the standard full size model.

It sounds like a fairly significant improvement. It might be worth having a spare if they would sell you one in case you break another.

How much difference in trigger pull weight does that spring make vs stock?

I used the Beretta spacers in my CR Speed pouches for the P320, and don't have any wiggle. They space the side as well as the back.

Sent!

I've used my XDm Bitone for about a year, with quite a bit of draw/dry fire practice out of a Bladetech with no signs of holster wear.

I used a 16# spring, and stock firing pin spring with 122 PF loads for the Big Dawg Steel match with no problems in my XDM 40.

I had a problem with my M&P 9mm failing to extract causing jams like you mentioned. I was told by one of the Team S&W guys that a few of these guns got Melonite overspray in the chambers causing the chamber to be a little rough. I polished my chamber and the problem went away.

I've installed 2 Ice magwells without modification to the frames. On one I did need to file a little material from the brass inset though. The mags with Arredondo pads seat easily.

Smith and Alexander for me.

That's horrible news. I'll be praying for those boys.

I had the same problem. I gave up and glued the base pad on with 3M moulding and trim adhesive that I got at an auto parts store.

Nothing but Bladetech for me.

I've found that my mags that use the #5 followers will hold a reloadable 20 rounds, but the ones with the #6 followers won't. The followers are not interchangable so the mag bodies are different.

My Dawson Ice and Arredondo's play nice together.

I'm Shooting Friday.

I had problems with that stage at the Single Stack Nationals last year. My plan was to put the mags back in the pouches, then shoot the stage. When i tried to shove the first mag in to the blade-tech pouch the top round slid forward and things went down hill from there. I ended up shooting the stage strong hand while holding the rest of the mags. I actually shot the stage pretty good that way once I got going. I have since beveled the openings of my blade-tech pouches which might help if I try that stunt again.

I use it and like it.

So far Area 3 has 105 entries and only 4 are Single Stack division entries. It's still over a month and a half away so more will probably register. I would like to see a strong showing for that division.