stiblaster

I believe the Magpul 12 round mags keep you in compliance. They have a slightly shorter extension.

I just encountered the Norma brass with small flash hole. What a pain. I toss every one I see now.

I got some of these. They seem to work fine. https://www.ebay.com/itm/Replacement-Sig-Sauer-P250-9MM-Magazine-Spring-2-Pack-Mag-Springs/273612469536?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

I've had Dawsons on most of my other pistols, and like them a lot. That's what I decided to order for the P320.

Anyone using the Trijicon fiber optic sights on their P320?https://www.trijicon.com/na_en/produ...uct1.php?id=FS

Is this just a 9mm problem, or has this been reported with other calibers?

My P320 .40 caliber doesn’t have nearly as much case exposed as that. Mine is the standard full size model.

It sounds like a fairly significant improvement. It might be worth having a spare if they would sell you one in case you break another.

How much difference in trigger pull weight does that spring make vs stock?

I used the Beretta spacers in my CR Speed pouches for the P320, and don't have any wiggle. They space the side as well as the back.

Sent!

I've used my XDm Bitone for about a year, with quite a bit of draw/dry fire practice out of a Bladetech with no signs of holster wear.

I used a 16# spring, and stock firing pin spring with 122 PF loads for the Big Dawg Steel match with no problems in my XDM 40.

I had a problem with my M&P 9mm failing to extract causing jams like you mentioned. I was told by one of the Team S&W guys that a few of these guns got Melonite overspray in the chambers causing the chamber to be a little rough. I polished my chamber and the problem went away.

I've installed 2 Ice magwells without modification to the frames. On one I did need to file a little material from the brass inset though. The mags with Arredondo pads seat easily.