Jump to content
Brian Enos's Forums... Maku mozo!

Fmantee

Members
  • Posts

    18
  • Joined

  • Last visited

Everything posted by Fmantee

  1. Has anyone heard of an autoload lifter for the Versa Max?
  2. A=.350 B=1.8245 C=1.8535 I did not remove the mag release but these should be pretty close.
  3. I am loading 9mm on my 1050. My finished round comes out with a small indent all the way around the shell where the bottom of the projectile is so you can actually see the profile of the projectile on the outside of the shell. What do I need to adjust to get rid of this?
  4. I used to have that "jump" until I figured out it was the Case Insert Slide and Slide Cam (part no. 97082) pushing the empty shell into the shell plate too soon. I adjusted the Camming Pin (part no. 13371) until the shell plate advanced and stopped and then the Cam would push the empty shell in. I have not tipped any bullets over or lost any powder since then. Read about it on here somewhere. Got rid of years of frustration.
  5. I read in the rules somewhere about coating the exterior. I think that is a no no. You should check into it before it changes your division.
  6. I had mistakenly placed that spring steel where the red X is. Picture shows it in the right spot.
  7. Figured it out. There is a piece of spring steel that is on the exit from the case feeder. It should be on the left side so the bottom of the case contacts it and drops into the tube. Some dummy (me) moved it to the bottom of the slot which would allow a shell to get underneath.
  8. I have started loading .223 and I am finding that the .223 brass is getting underneath the small rifle plate and jamming things up. Has anyone experienced this before and how do I resolve?
  9. Here is a great link and in depth explanation of what to do. It is done with a CZ but Tango is pretty close.
  10. Please take a look at the following link with kneeling atlas. It is a phenomenal resource. Although it is CZ obviously it applies to Tango too. Absolutely nothing wrong with using sandpaper. I have used on multiple Tanfoglios and CZ.
  11. I am 6'. My bench is 38" off the floor. My 650 has a strong mount and the handle is almost 53" off the floor. It is great for me.I stand while reloading.
  12. I run Carbon Arms on my ELS belt and they have enough holes to attach the clips.
  13. I run a 650 and the only time I saw this happening was in Station 1 not being centered properly and the sizing die creating the roll.
  14. Was out looking at shotguns today and found that I really liked the Benelli Speedbolt. My primary use would be 3 Gun. Anyone have any opinions?
  15. I used Cam Pro 124g HP with 5.0 grains of CFE, OAL of 1.095 and got 127 pf.
×
×
  • Create New...