DukeSoprano

https://www.amazon.com/dp/B003F6FKBA?psc=1&ref=ppx_yo2ov_dt_b_product_details

I would stick with Super, I carry a Dan Wesson Guardian in 38 Super and I can buy self defense ammo at my local gun shop (well I could)

If you get bored, try a fixed time classifier

Thanks for all this, I love it

Can it have a 38 Super cylinder too???

My local ACE has a few drawers that are even marked "Gun Screws"

Welcome from another 1911Addict member

I have a 627 in 38 Super and TK Smith & Wesson 929 9mm OEM Moon Clips STD B/S, work perfectly with almost all brands of brass. I have a totes full of brass and don't even sort it, sometimes I get a round that is too loose and I just toss into a box to shoot out of my 1911s

IS there an easy way to change the weight of the bullet? Using the phone app Friday I tested 14 loads and 2 of them were different weights then the rest, I ended up leaving the unit on 200gr and did the math for the 230s when I got home

I do not think there is a way to Arm the unit from your phones app. I going to play with mine in a minute and Ill check it out, whats frustrating for me is changing the weight of the bullet. I went to the range Friday and tested some 200gr bullets vs 230gr and I would like the app to ask me what grain bullet im using. All I do is type in the FPS into a spreadsheet I made and it calculates the PF for me

I put the comp 4 to 6 inches downrange of the unit

https://americasgunsmithshop.com/ Is another great place to deal with

This happened to my buddies 929 and it took like 6 months when he sent it to S&W. By the time they even looked at it, months had passed and then they realized it was a Performance Center gun so they had to send it to that department and the wait started all over again.

Are you going to reload for it?

I reload them in Short Colt and 38 Super for my 3, 627s

Yes I am using Redding micro dies, Thanks for the advice

Reloading for my S&W 627 in 38 Super, .358 blue bullet, 160 gr. Dillon 650. I have tried the 38 Super/9mm powder drop/flare and 38 Special. Both of them lead to me shaving a bit of coating off the bullet when seating, no matter how much flare I have. I have read about Mr. Bullet Feeder and Uniquetek Any recommendations? Thank you,

Where is the spring on the wishbone for the lock? Are you sure the wishbone isnt moving forward a bit and allowing the lock to contact the hammer? Or allowing the lock to engage?

We also have a great time in Polo IL https://practiscore.com/tcgc-polo-march-2024-special-classifier/register

https://winnequahgunclub.org/

I have been installing, Apex, TK Diamond and even carving up stock hammers in N frames and all are around 5LB trigger pulls with Wilson Combat springs. Of course we all use federal primers

Do you reload?

Are you ever going to have them in stock again for N frames?

I am going to try a 510 I took off my pcc.