LilBunniFuFu

Meh. They're okay guns.

Same stage in question. The WSB has been posted a few times. I just looked in the competitor app and found the exact procedure they dinged me with.

The second procedural I got was given under 10.2.4 The explanation was that the stage procedure state engage with only two rounds then a mandatory reload. So I got on for an extra shot on virginia count and one for reloading at the wrong time. Also of note the CRO of the stage is a well known one who works lots of matches here and abroad. MD's a few of them as well.

Yea. I did the same thing and he said the same exact zero sentence to me. Well. 3 on the first, made up a ND, reload then 2 and 2. One penalty extra shot. One penalty for not following stage procedure. 6A 1NS 2P for a zero. If I had taken the Mike and NS I would've had 4 points and if it was only one P then I would've gotten 7 stage points. I was only 2 points behind the competitor who finished ahead of me!

You are paying for the name, manufacturing process, and the material. Honestly they all work just what's easier to install as others have written. We primarily use the egw grip safeties.

My mistake. I wasn't away that match actually counted especially so with the hurricane going on.

Specifically CO. There hasn't been a match that fulfills the requirements for classification or match bump yet. It's completely automated now.

It hasn't counted for a classifier at any major match yet.

Preach brother.

Yea. I've never had an issue either. Just told him to keep an eye out since he is worried about it.

In a 38 short colt case trimmed down to their "trainer" cartridge. It's ridiculous the projectile alone was longer than the casing.

In my experience jacketed and coated are fine. The plated stuff will sometimes throw fliers. Had good luck with the heavy plated stuff from berry's before. I'd say buy a case check accuracy while keeping an eye out for leading.

Buy s#!t used. Sell and trade for other stuff. You're looking at a new atlas, why? Plenty of nicely done eagles go through the classifieds for cheap.

My buddy used to load major with a 260 grain loaded in a trimmed short colt case using some s#!t CBC powder in Brasil.

Same trigger bow? Could be the over travel screw. Need more info to correctly diagnose. There is a lot that can change by changing the plastic out.

You really should see it but when he is actually training normally.

Yea... That's not going to happen. There were only two GM shooters. One won the division and the other shot in the 70's does not count for classification so no match bump.

You also need to remember that the equipment survey doesn't separate what powder by calibre. The majority of that data is used in 38.

Ben Berry is up there and has started doing training recently. He has a podcast and some other stuff. Might be able to work something out with him after nationals.

Sellier and Bellot SRP, it's hard and cheap. CCI SRP if I am loading match ammo.

A 45 degree mount gets it a tad lower but that opens up a whole other bucket of worms.

Will it do it with other mags? are you sure the meat on your hands isn't riding the slide stop?

Used minimags almost exclusively when shooting matches, federal bulk for everything else.

I've used WAC but ditched it for HS-6. I do have a jug of CFE pistol but I haven't shot enough open recently to merit playing with it.

Probably won't be CO legal without mill work since ProdOps has no weight limit.