[.223 bullets]

Thanks!

[.223 bullets]

Does anybody have a good source with .223 bullets 55gr in stock? price around $.10 a round same thing with powder?

[40 S&W 155gr leadsafe reloading data (OAL)]

Does anyone use rainier leadsafe restrike bullets? I have some for 40 S&W 155gr flat point total copper jacketed. I normally use power pistol. I was wondering what your normal OAL is with these bullets? Also how much powder do you use? My OAL seems a little bit shorter than normal.

[650 Primer Arm Spring]

problem solved. I guess I just needed to post it and look stupid.

[650 Primer Arm Spring]

These may help.

PrimerIndexSpring_1.jpg

PrimerIndexSpring_2.jpg

You basically put the spring on the arm, stick the other end into the slot on the body and then put the shaft through the hole in the arm and then into the hole in the body.

Later,

Chuck

how do I put the other spring on?

[650 Primer Arm Spring]

correction I can not get the indexing arm spring back into place. I can not figure out how it goes in there.

[650 Primer Arm Spring]

xl650

[650 Primer Arm Spring]

I took the primer station locator tab off and the indexing ARM spring went flying off. How and where does it go?

[Dilon XL 650 retaining screw on shaft (Help Im losing my mind)]

Move the indexing ring round so that the hole is on the right side of the ring and put the screw in..... It will never go in while the indexing ring is covering part of the hole.

I did do that though

[Dilon XL 650 retaining screw on shaft (Help Im losing my mind)]

Problem solved I just used a drill to force it in now it works just fine. I think the hole was not tapped all the way. Thanks for the suggestions problem solved.

[Dilon XL 650 retaining screw on shaft (Help Im losing my mind)]

still no luck I can get it about half way in now and it is stuck.

[Dilon XL 650 retaining screw on shaft (Help Im losing my mind)]

I definitely will not take it out all the way next time. I just wish I could get them all the way back in.

[Dilon XL 650 retaining screw on shaft (Help Im losing my mind)]

I have two brand new 650's with the same problem. I took the screw out to replace the shell plate and it will not go back in. I thought maybe it was the machine so I tried it on another brand new 650 same problem. What am I doing wrong? I can get it in there a little then it just stops I do not want to force it because maybe it isn't going in the correct way. I tried a little wd-40 with no luck. attached is a pic. The pic is bad because I had to reduce the file size.