camui9999

Hi Todd, Please add me to the wait list for 2 cases of 9mm standard sort. Thanks as always. MC

Short DA/reach disconnector is recommended by czc. If you have a short SA reset disconnector, it will need to be fitted, this includes cgw T1-T5 disconnectors, the T6 from the cgw short reach kit is probably the least amount of fitting needed. The CZC disconnector from their short reach kit will work with no fitting.

So i had a friend mill down and checkered the trigger. Feels really good for me. The set screws were put there just in case too much was taken off, but turn out there was enough meat on the trigger and they were not needed.

My initial impression of the extra length to reach the trigger was no concern, i hardly notice the extra reach and single action feels awesome. Might try to file the trigger face down and do some checkering on a second trigger.

Put this in today, this will add some length to the reach in DA. The overall pull length is the same. picture is a compare to the cgw short reach.

At the minimum. - TRS spring - Recoil spring If you shoot alot of matches, then below additional - Slide stop - Spare firing pin - Firing pin spring or a backup S2 I have been good changing springs so haven't had any issues with things breaking during a match.

Ordered one for my S2, hopefully it will be here during the week so i can install and test over the weekend. I currently run the trigger that comes with the CZC short reach kit with the CGW short reach kit disconnector in one of my S2 and had to do some minor fitting on the disconnector. I'm also tempted to drill and tapped some set screws to make this adjustable.

i figure i buy a 1911 everytime i need a new mag, that way i wont be pissed off about what i cant have lol

Hi All, I just started USPSA a few months back. I been on here a few times and seen lots of helpful info. Nice to meet you all. MC